AIRLIVE WL-5460APV2 DESCARGAR CONTROLADOR

Support Support IAPP.

Page 6: Front Panel: Status Turns solid red when the device is booting, after boot successfully, AirLive WL-5460APv2 light turn off. Page 7 2.

Rear Panel: Performing the Factory Reset will erase all previously entered device settings. Page 8: Channel Default value: Disabled IP Address Page 9: Before you starting hardware connection, you are advised to find an appropriate location to place the Access Point. Usually, the best place for the Access Point is at the center of your wireless network, with line of straight to all your wireless stations. Page If you want to change the settings in order to perform more advanced configuration or even change the mode of operation, you can use the web-based utility provided by the manufacturer as described in AirLive WL-5460APv2 following sections.

All stations can have the Internet access if only the AirLive WL-5460APv2 Point has the Internet connection. See the sample application below.

Universal Repeater Mode - Air Live WLAP V2 Quick Setup Manual [Page 9]

Refer to the illustration below. For AirLive WL-5460APv2 configuration, the Passphrase at least 8 characters format is recommended. Group Key Life Time Enter the number of seconds that will elapse before the group key change automatically. The default is seconds. None No data encryption and Use WEP It is more secure than WEP encryption.

Pre-authentication provides a way to establish a PMK security association before a client associates. The advantage is that the client reduces the time that it's disconnected AirLive WL-5460APv2 the network. The default is IP Address: Fragment Threshold Fragmentation mechanism is used for improving the efficiency when high traffic flows along in the wireless network. If your Hidden Node is a situation AirLive WL-5460APv2 which two stations are within range of the same Access Point, but are not within range of each other.

Screenshots - Airlive - WLAP V2 (Airlive Firmware) ™

Therefore, they are hidden nodes for each AirLive WL-5460APv2. When a station starts data transmission with the Access Point, it might not notice that the other station is already using the wireless medium. When these two stations send data at the same time, they might collide when arriving simultaneously at the Access Point. The collision will AirLive WL-5460APv2 certainly result in a loss of messages for both stations. Thus, the RTS Threshold mechanism provides a solution to prevent data collisions. Upon receipt, the Access Point will respond with a CTS message to all station within its range to notify all other stations to defer transmission.

It will also confirm the requestor station that the Access Point has reserved it for the time-frame of the requested transmission. If the Hidden Node problem is an issue, AirLive WL-5460APv2 specify the packet size. The RTS mechanism will be activated if AirLive WL-5460APv2 data size exceeds the value you set.

Screenshots - Airlive - WL-5460AP V2 (Airlive Firmware)

The default value is Enabling RTS Threshold will cause redundant network overhead that could negatively affect the throughput performance instead of providing a AirLive WL-5460APv2. This value should remain at its default setting of If set channel manually, just select the channel you want to specify. AirLive WLAP v2 User Manual. 1.

Air Live WL-5460AP v2 User Manual

WLAP . The WLAPv2 features the new Wireless Client Isolation function previous available only in more.

AirLive(歐立科技) is a AirLive WL-5460APv2 IP Surveillance Networking solutions which provide solutions both surveillance and network solution, products includes: Fiber.